ORIGO FEED 304 M12

Optimized to operate together with the Origo MIG 320/410's. The Origo Feed M12 is a basic wire feeder for use with these step-controlled power sources. It features an accurate wire feed speed dial, slow wire run-in, burn-back control and torch trigger locking. Wire inching and gas purging are optional. A 23-pin remote receptacle is installed ready to connect MiggyTrac, RailTrac and Push-Pull Torches. A wire reel cover is standard.

Features:

• WFS range 31-1000 ipm
• 2/4 stroke – simplifies welding
• Adjustable burn-back timer – gives correct stickout
• Creep start – gradual feed of wire for ultimate starts
• Quick connectors – shortest possible setup times
• Multiple mounting options – counterbalance and mast, wheel kit, or hanging bracket
• Inching/gas purge (optional)